enclosed variable speed drive ATV31 - 1.5 kW - 380..500 V 3-phase supply

Артикул: ATV31CU15N4T


ATV31CU15N4T
enclosed variable speed drive ATV31 - 1.5 kW - 380..500 V 3-phase supply




Характеристики
Main
Range of product Altivar 31
Product or component type Variable speed drive
Product destination Asynchronous motors
Product specific application Simple machine
Wire guiding
Assembly style Enclosed
Component name ATV31
EMC filter Integrated
Power supply voltage 380...500 V (- 15...10 %)
Power supply frequency 50...60 Hz (- 5...5 %)
Network number of phases 3 phases
Motor power kW 1.5 kW
Motor power hp 2 hp
Line current 4.8 A for 500 V and 1 kA
6.4 A for 380 V and 1 kA
Apparent power 4.2 kVA
Maximum prospective line Isc 5 kA
Maximum transient current 6.2 A during 60 s
Power dissipation in W 61 W at nominal load
Speed range 1...50
Transient overtorque 150...170 % of nominal motor torque
Asynchronous motor control profile Factory set : constant torque
Sensorless flux vector control with PWM type motor control signal
IP degree of protection IP55
Complementary
Power supply voltage limit 323...550 V
Power supply frequency limits 47.5...63 Hz
Continuous output current 4.1 A at 4 kHz
Speed drive output frequency 0.5...500 Hz
Nominal switching frequency 4 kHz
Switching frequency 2...16 kHz adjustable
Braking torque 50 % without braking resistor
100 % with braking resistor continuously
? 150 % with braking resistor for 60 s
Regulation loop Frequency PI regulator
Motor slip compensation Adjustable
Automatic whatever the load
Suppressable
Output voltage <= power supply voltage
Electrical connection Terminal 2.5 mm? / AWG 14
Terminal 2.5 mm? / AWG 14
Tightening torque Al1, Al2, Al3, AOV, AOC, R1A, R1B, R1C, R2A, R2B, LI1...LI6 0.6 N.m
L1, L2, L3, U, V, W, PA, PB, PA/+, PC/- 0.8 N.m
Insulation Electrical between power and control
Supply Internal supply for logic inputs 19...30 V , > 0...0.1 A for short-circuit protection
Internal supply for logic inputs 19...30 V , > 0...0.1 A for overload protection
Internal supply for reference potentiometer 10...10.8 V , > 0...0.01 A for short-circuit protection
Internal supply for reference potentiometer 10...10.8 V , > 0...0.01 A for overload protection
Analogue input number 3
Analogue input type AI1 configurable voltage 0...10 V , input voltage 30 V max , impedance 30000 Ohm
AI2 configurable voltage +/- 10 V , input voltage 30 V max , impedance 30000 Ohm
AI3 configurable current 0...20 mA , impedance 250 Ohm
Input sampling time Analog AI1, AI2, AI3 8 ms
Discrete LI1...LI6 4 ms
Output response time Analog AOV, AOC , 8 ms
Discrete R1A, R1B, R1C, R2A, R2B , 8 ms
Linearity error +/- 0.2 % for output
Analogue output number 2
Analogue output type AOC configurable current 0...20 mA , impedance 800 Ohm , resolution 8 bits
AOV configurable voltage 0...10 V , impedance 470 Ohm , resolution 8 bits
Discrete input logic LI1...LI4 logic input not wired , state 1 < 13 V
LI1...LI6 positive logic (source) , state 0 < 5 V , state 1 > 11 V
LI1...LI6 negative logic (source) , state 0 > 19 V
Discrete output number 2
Discrete output type R1A, R1B, R1C configurable relay logic 1 NO + 1 NC 100000 cycles
R2A, R2B configurable relay logic NC 100000 cycles
Minimum switching current R1-R2 10 mA at 5 V DC
Maximum switching current R1-R2 on resistive load, 5 A at 250 V AC, cos phi = 1, L/R = 0 ms
R1-R2 on resistive load, 5 A at 30 V DC, cos phi = 1, L/R = 0 ms
R1-R2 on inductive load, 2 A at 250 V AC, cos phi = 0.4, L/R = 7 ms
R1-R2 on inductive load, 2 A at 30 V DC, cos phi = 0.4, L/R = 7 ms
Discrete input number 6
Discrete input type LI1...LI6 programmable 24 V , 0...100 mA compatible with PLC , impedance 3500 Ohm
Acceleration and deceleration ramps S, U or customized
Linear adjustable separately from 0.1 to 999.9 s
Braking to standstill By DC injection
Protection type Drive short-circuit between motor phases
Drive input phase breaks
Drive motor phase breaks
Drive line supply phase loss safety function, for three phases supply
Drive line supply overvoltage and undervoltage safety circuits
Drive overcurrent between output phases and earth (on power up only)
Drive overheating protection
Motor thermal protection
Insulation resistance ? 500 MOhm at 500 V DC for 1 minute
Local signalling 1 LED (red) for drive voltage
Four 7-segment display units for CANopen bus status
Time constant 5 ms for reference change
Frequency resolution Analog input 0.1...100 Hz
Display unit 0.1 Hz
Communication port protocol CANopen
Modbus
Type of connector 1 RJ45 for Modbus
1 RJ45 for CANopen via VW3 CANTAP2 adaptor
Physical interface RS485 multidrop serial link for Modbus
Transmission frame RTU for Modbus
Transmission rate 10, 20, 50, 125, 250, 500 kbps or 1 Mbps for CANopen via VW3 CANTAP2 adaptor
4800, 9600 or 19200 bps for Modbus
Number of addresses 1...127 for CANopen via VW3 CANTAP2 adaptor
1...247 for Modbus
Number of drive 31 for Modbus
127 for CANopen via VW3 CANTAP2 adaptor
Marking CE
Operating position Vertical +/- 10 degree
Product weight 8.8 kg
Environment
Dielectric strength 2410 V DC between earth and power terminals
3400 V AC between control and power terminals
Electromagnetic compatibility 1.2/50 ?s - 8/20 ?s surge immunity test conforming to IEC 61000-4-5 level 3
Electrical fast transient/burst immunity test conforming to IEC 61000-4-4 level 4
Electrostatic discharge immunity test conforming to IEC 61000-4-2 level 3
Radiated radio-frequency electromagnetic field immunity test conforming to IEC 61000-4-3 level 3
Standards EN 50178
Product certifications C-Tick
CSA
N998
UL
Pollution degree 2
Protective treatment TC
Vibration resistance 1 gn (f = 13...150 Hz) conforming to EN/IEC 60068-2-6
1.5 mm (f = 3...13 Hz) conforming to EN/IEC 60068-2-6
Shock resistance 15 gn for 11 ms conforming to EN/IEC 60068-2-27
Relative humidity 5...95 % without condensation conforming to IEC 60068-2-3
5...95 % without dripping water conforming to IEC 60068-2-3
Ambient air temperature for storage -25...70 °C
Ambient air temperature for operation -10...50 °C without derating with protective cover on top of the drive
-10...60 °C with derating factor without protective cover on top of the drive
Operating altitude ? 1000 m without derating
? 1000 m without
? 1000 m with current derating 1 % per 100 m
RoHS EUR status Will not be compliant


Назад в раздел

Новое вдохновение – Шнейдер Электрик

Стильные и модные выключатели,
розетки и системы управления

unica_top2.png
merten-antique2.png
merten-system2.png
unica_basic2.png
sends.png
prima.png
rondo.png
W59.png